how to fix knitting errors

How To Fix Knitting Errors?

While knitting, if you drop a stitch, twist a cable, or make a wrong color change, don’t panic.

There are ways to fix knitting errors without unraveling your whole project.

In this article, we will show you some common knitting errors and how to fix them.

Dropped Stitches

A dropped stitch is when a loop of yarn slips off the needle and unravels. This creates a hole in your knitting and a loose strand of yarn.

You will need a crochet hook or a spare knitting needle to fix a dropped stitch.

Here are the steps:

  1. First, locate the dropped stitch and the loose strand of yarn above it. The loose strand is the one that was supposed to go through the dropped stitch.
  2. To fix a dropped stitch in knitting, insert a hook or needle into the stitch from front to back, then pull the loose strand through to create a new loop.
  3. Repeat this process for each loose strand above the dropped stitch until you reach the current row of your knitting.
  4. Finally, transfer the loop from the hook or the needle to the left-hand needle, making sure that the loop is not twisted. Then, continue knitting as normal.

Twisted Cables

A twisted cable is when you cross the stitches in a cable pattern in the wrong direction.

This creates a cable that looks distorted or out of place. To fix a twisted cable, you will need a cable needle or a spare knitting needle.

how to fix knitting errors
You can fix knitting errors.

Furthermore, below are the steps:

  1. First, identify the row where you made the mistake and the stitches that are involved in the cable. You must undo the stitches above the cable until you reach the row where the mistake occurred.
  2. Transfer cable stitches to cable needle. Let them hang. Unravel non-cable stitches to the same row as cable stitches.
  3. Next, hold the cable stitches in place with a cable needle, cross them in the correct direction, then knit the cable stitches and other stitches following the cable pattern.
  4. Finally, continue knitting as normal until you reach the end of the row.

Wrong Color Changes

A wrong color change is when you switch to a different color of yarn in the wrong place or in the wrong way.

Additionally, this creates a color pattern that does not match your intended design.

To fix a wrong color change, you will need a tapestry needle and some scissors.

Here are some ways:

  1. To fix a mistake in your knitting, locate the affected row and stitches, cut the wrong color yarn, and remove it carefully, leaving a tail on both ends.
  2. Thread the tapestry needle with the correct color yarn. Weave through the stitches affected by the wrong color, following the pattern. Leave a tail of yarn on each end.
  3. Next, secure the tails of yarn by weaving them through the back of the work, or by tying them to the adjacent yarn ends. Then, trim the excess yarn with scissors.
  4. Finally, continue knitting as normal, using the correct color of yarn.

Conclusion

Knitting errors are inevitable, but they are not irreversible.

It’s important to remember that even the most experienced knitters make mistakes, so it’s essential to stay patient and not get discouraged.

You can learn how to fix knitting errors without ruining your project with some patience and practice. You can fix three common knitting errors: dropped stitches, twisted cables, and wrong color changes.

Moreover, you can correct these mistakes using simple tools and techniques and restore your knitting to its original beauty.

Also read more about How To Pick Up A Missed Knit Stitch.

Leave a Comment

Your email address will not be published. Required fields are marked *